Multitech MT5634HD16 Guia do Utilizador descarregar pdf (Página 26)

RASExpress User Guide

16 CommPlete Communications Server

Introduction

The CommPlete Communications Server RAS96 RASCard ships with RASExpress

pre-installed. (Throughout this user guide, the RASCard with RASExpress installed is

referred to as the RASExpress server.) All you need to do to get RASExpress up and

running is to configure it for your particular operation. Should the hard disk become

damaged or the software corrupted, you can reinstall and configure RASExpress fol-

lowing the instructions in Appendix A.

You can configure and manage the RASExpress server either locally, using a

terminal, or remotely, using Telnet, a World Wide Web browser, or the

MultiCommManager SNMP manager.

This chapter describes the menus for the terminal and the Telnet interfaces. For

remote management using Telnet commands, see Appendix C. For remote

management using a Web browser, see Chapter 4. For remote management using

MultiCommManager, see the MultiCommManager User Guide.

How to Access RASExpress

Using a Terminal

To enable remote configuration of the RASExpress server, you must first configure

the server’s IP settings, including the server’s IP address. To do this, you must

connect a terminal to the server’s serial port. Once IP is configured and working, you

can complete the server configuration either locally, through the terminal, or

remotely, through Telnet, a browser, or MultiCommManager.

1. Using the provided RS-232C serial cable, connect a terminal to the RASExpress

server’s configuration port.

2. Turn on the RASExpress server and the terminal, and then press ENTER. The

RASExpress main menu appears.

Using Telnet

Using Telnet for access requires a TCP/IP protocol stack to be loaded on the client.

Telnet access is possible both by dialing in through the RASExpress server and, more

commonly, through the LAN or Internet.

Dial-In Access

1. Dial in to the RASExpress server using a terminal program. A login prompt

appears.

2. Enter a valid user name and password. A menu appears.

3. Select Telnet Session from the menu.

4. Enter the IP address of the RASExpress server.

5. The RASExpress main menu appears.

TCP/IP Access

1. Run your Telnet software, and connect to the IP address of the RASExpress server.

2. The RASExpress main menu appears.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 291 292

Sem comentários

Multitech MT5634HD16 Guia do Utilizador Página 26