71-IWay Hopper
Troubleshooting
4 Check the serial port baud rate in your communications software, and make
sure it is set as high as your UART allows.
Data Is Being Lost
4 Your UART may not be reliable at serial port speeds over 9600 bps or 19,200
bps. Reset your serial port speed to a lower rate, or replace your serial port with
a faster one.
4 Check the serial port baud rate in your communications software, and make
sure it is set as high as your UART allows.
4 Make sure the flow control method you selected in software matches the meth-
od selected in the MTA128ST.
There Are Garbage Characters on the Monitor
4 Your computer and the remote computer may be set to different parities. Check
with the remote system with which you are communicating, and set your com-
munications software to use the same parity as the remote system.
Comentários a estes Manuais