Multitech MTA128ST Manual do Proprietário descarregar pdf (Página 45)

45-IWay Hopper

AT Commands/S-Registers

&F0 Profile 0  Modem-like operation (default)

&F1 Profile 1  V.110 async operation

&F2 Profile 2  V.120 async operation

&F3 Profile 3  X.75 async operation

&F4 Profile 4  MLPPP async operation

Command: &Mn

Function: Asynchronous Mode

Values: n = 0 or 1

Default: &M0 (Asynchronous)

Description: Use the &Mn command to set the MTA128ST for synchronous or

asynchronous transmission. Note that synchronous transmission is not presently

supported, and this command is included for future use only.

&M0 Asynchronous mode transmission.

&M1 Synchronous mode transmissionnot presently supported.

Command: &Rn

Function: CTS Control

Values: n = 0, 1, or 2

Default: &R1 (CTS forced high)

Description: The &Rn command lets you control the state of the CTS (Clear to

Send) signal on the RS232E/V.24 interface. Normally the CTS signal follows the

state of the RTS signal when the MTA128ST is online.

&R0 CTS acts normally; that is, it follows RTS.

&R1 CTS is forced high, but still provides online flow control.

&R2 CTS is forced high, but it drops on disconnect for the period of time

set by S10. CTS still provides flow control when the MTA128ST is

online.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 116 117

Sem comentários

Multitech MTA128ST Manual do Proprietário Página 45