Multitech MTASR3-200 Guia do Utilizador descarregar pdf (Página 9)

Chapter 1 - Introduction and Description

MTASR3-200

Back Panel

The cable connections for the RASFinder are made on the back panel. Three groups of cables are

used on the RASFinder: the Command port, three RJ-11 ports (Links 1, 2, and 3), and the Ethernet

port. The cable connections are shown in Figure 1-3 and defined in the following groups.

Figure 1-3. Back Panel

Link Connectors (Links 1, 2, and 3)

These Link connectors are used to connect the RASFinder to a WAN. These connectors are RJ-11

connectors.

Ethernet 10Base-T Connector

The Ethernet 10Base-T connector is used to connect the RASFinder to a LAN using unshielded

twisted cable. This connector is an RJ-45 jack.

Command Connector

The Command connector is used to configure the RASFinder using a PC with a serial port and

running Windows

software. The Command connector is an RJ-45 jack and a short adapter cable is

provided to convert to a standard serial port DB25 female connector.

Power Connector

The Power connector is used to connect the external power supply to the RASFinder. The Power

connector is a 6-pin circular DIN connector. A separate power cord is connected to the power supply

and the live AC grounded outlet.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 112 113

Sem comentários

Multitech MTASR3-200 Guia do Utilizador Página 9