Multitech MMH900 Guia do Utilizador descarregar pdf (Página 93)

Chapter 5 - Commands

7 To reconfigure a channel based on your actual channel

requirements, enter commands as described in Chapter 5 or

Appendix D of this manual. To save new parameters, you must again

execute an AT&W command.

Downline Load

8 If you are downline loading remote parameters, your 8-position DIP

switch SW1 must be in the UP (open) position, refer to the 8-position

DIP Switch in the Configuration Chapter (Chapter 3) of this manual.

The other mux in your network must be configured properly and

have its 8-position DIP switch SW1 in the DOWN (closed) position.

You then can execute a Reset command (Z) to send the new

parameters to your remote mux unit. An MMH904/MMH908 unit

cannot down line load parameters to an MM16/MM32 or MMH16/

MMH32 unit.

9 To return to local parameter display and control, execute a Select

Local Parameter command by entering the following:

AT&SL (hit Return)

Status Reporting

10 If you wish to use the status display and auto reporting feature,

execute the Status Reporting command by entering the following:

AT#S0 (hit Return)

The following will be displayed on your system monitor:

ELAPSED TIME : 00 DAYS 00 HRS 00 MIN.

BLOCKS TRANSMITTED : 0

RETRANSMITS : 0

BLOCKS RECEIVED : 0

RECEIVE BLOCK ERRORS : 0

LINK ALARMS : 0

REMOTE DOWNS : 0

RECEIVE FLOW CONTROL TIME: 00 HRS 00 MIN 00 SEC.

AUTOMATIC REPORTING : OFF 9600 BAUD

To select the bps rate and time interval at which the above status

screen will appear, execute a #RBxx and #RTxx commands as

described in Chapter 5 or Appendix D of this manual.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 199 200

Sem comentários

Multitech MMH900 Guia do Utilizador Página 93