Multitech MTCBA-C-U-N2 Especificações descarregar pdf (Página 62)

Chapter 3 – Status Control Commands

Multi-Tech Systems, Inc. AT Commands for EDGE (E1) Modems (S000474A) 62

3.5 ATS18 Extended Call Release Report

Description: ATS18 controls the presentation of extended call release reports for circuit switched data calls.

Extended call release reports related to voice calls are controlled via AT+CEER.

The call release report is presented in numeric format and shows as follows:

+CAUSE: <locationID>:<reason>

If enabled the message will be reported every time a data call is released or fails to be

established.

Syntax: Read Command: ATS18?

Responses: <n>

Write Command: ATS18=<n>

Responses: OK

ERROR

Parameters:

<n>

An odd number enables the presentation of the extended call release report. Any even

number disables this feature. This parameter can be stored with the AT&W command. It

can be displayed with the AT&V command. The default is 0.

0...255. Default = 0 (This is factory default value, will be restored to 0 with AT&F.

This value can be stored with AT&W.

This value can be displayed with AT&V.

Location ID as number code, see also <locationID> of AT+CEER.

Location IDs are listed in Section 3.4.1, Cause Location ID for the extended error report.

Each ID is related to another table that contains a list of <reason>s.

Reason for last call release as number code (see also <reason> of AT+CEER).

<reason> numbers and the associated descriptions are listed in several tables, sorted

by different categories at AT+CEER. The tables can be found proceeding from the

Location IDs listed in Section 3.4.1, Cause Location ID for the extended error report.

Examples:

Example 1

ATS18=1 Enables the presentation of extended call release reports.

ATD03012345678 Now, a mobile originated data call fails.

+CAUSE: 8:17 An extended error report is output, followed by the result code BUSY.

BUSY The Location ID 8 stated in Section 3.4.1 points to Section 3.4.4, with 17 = “User

busy”.

Example 2

ATS18=1 Enables the presentation of extended call release reports.

ATD03012345678 Now, a mobile originated data call is set up.

CONNECT 9600/RLP

Hello,....

+++ Call ends after remote party hung up.

+CAUSE: 8:16 Normal call release is reported, followed by the result code NO CARRIER.

NO CARRIER The Location ID 8 stated in Section 3.4.1 points to Section 3.4.4, with 16 = “Normal

call clearing”.

Notes:

• This command is not PIN protected

• This command is supported in airplane mode

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 307 308

Comentários a estes Manuais

Sem comentários

Multitech MTCBA-C-U-N2 Especificações Página 62

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Multitech MTCBA-C-U-N2