Multitech MTCBA-C-U-N2 Especificações descarregar pdf (Página 22)

Chapter 2 – Configuration Commands

Multi-Tech Systems, Inc. AT Commands for EDGE (E1) Modems (S000474A) 22

2.6 ATX Set CONNECT Result Code Format and Call

Monitoring

Description: ATX determines whether or not the TA (terminal adapter) detects the presence of dial tone and

busy signal and whether or not the TA transmits particular result codes.

Syntax: Exec Command: ATX[<value>]

Response: OK

ERROR

Parameter: <value>

0 CONNECT result code only returned, dial tone and busy detection are both

disabled. Default value if the parameter is omitted (0 will be assumed).

1 CONNECT <text> result code only returned, dial tone and busy detection are

both disabled.

2 CONNECT <text> result code returned, dial tone detection is enabled, busy

detection is disabled.

3 CONNECT <text> result code returned, dial tone detection is disabled, busy

detection is enabled.

4 CONNECT <text> result code returned, dial tone and busy detection are both

enabled. Factory default value; will be restored to 4 with AT&F.

Notes:

• This command is not PIN protected.

• This command is supported in airplane mode.

• Store the parameters with the AT&W command.

• Display the parameters with the AT&V command.

2.7 AT\ V Set CONNECT Result Code Format

Description: This command sets the CONNECT result code format.

Syntax: Exec Command: AT\ V[<value>]

Response: OK

ERROR

Parameter: <value>

0 CONNECT <text> result code returned without RLP trailer. Default value if the

parameter is omitted (0 will be assumed).

1 CONNECT <text> result code returned with RLP trailer. Factory default value;

will be restored to 1 with AT&F.

Notes:

• For circuit-switched data calls only

• Output only if ATX parameter is set with value > 0.

• This command is not PIN protected.

• This command is supported in airplane mode.

• Store the parameters with the AT&W command.

• Display the parameters with the AT&V command.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 307 308

Sem comentários

Multitech MTCBA-C-U-N2 Especificações Página 22