Multitech MTPSR1-202ST Guia do Utilizador descarregar pdf (Página 14)

ProxyServer User Guide

MTPSR1-202ST

Adding Additional RAM

A second SIMM connector is provided for adding RAM to the ProxyServer. The procedure for adding

RAM is provided in Table 2-2.

Table 2-2. Adding Additional RAM Procedure

Step Procedure

1 Ensure that the external power supply is disconnected from the ProxyServer.

2 Turn the ProxyServer upside down and remove the cabinet mounting screw at the center back of

the cabinet. See Figure 2-3.

Cabinet Mounting Screw

(center, back)

Figure 2-3. Cabinet Mounting Screws

3 Turn the ProxyServer right side up, then slide the base out the rear of the cabinet.

4 Position the base so the front panel LEDs are toward you (as in figure 2-4).

5 Slant the SIMM at a 45

angle to the back of the base and align the centering notch of the SIMM

with the center tab on the SIMM connector.

6 Gently press down on the ends of the SIMM until the two short vertical white pins enter the holes

at the ends of the SIMM and the two metal side clips snap in place over the SIMM, locking it

down.

Figure 2-4. Installing a SIMM

7 Align the base with the mating guides on the inside of the cabinet, then slide the base all the way

into the cabinet until it stops.

8 Turn the ProxyServer upside down and replace the cabinet mounting screw that was removed in

step 2.

9 Turn the ProxyServer right side up and return to Table 2-1 to connect the cables.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 103 104

Sem comentários

Multitech MTPSR1-202ST Guia do Utilizador Página 14